# config for Intel PXA270
# not, as of 2007-06-22, openocd only works with the
# libftd2xx library from ftdi.  libftdi does not work.

# daemon configuration

telnet_port     3333
gdb_port        4444
tcl_port        6666

# Interface configuration

interface ft2232
ft2232_device_desc "Flyswatter"
ft2232_layout "flyswatter"
ft2232_vid_pid 0x0403 06010
jtag_speed 0

# set jtag_nsrst_delay to the delay introduced by your reset circuit
# the rest of the needed delays are built into the openocd program
jtag_nsrst_delay 260
# set the jtag_ntrst_delay to the delay introduced by a reset circuit
# the rest of the needed delays are built into the openocd program
jtag_ntrst_delay 250

#use combined on interfaces or targets that can't set TRST/SRST separately
reset_config trst_and_srst

#jtag scan chain
#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
jtag_device 7 0x1 0x7f 0x7e

#target configuration
#target <type> <endianess> <reset mode>
target xscale little reset_halt 0 pxa27x
#target_script 0 reset ./z2.ocd

# maps to PXA internal RAM.  If you are using a PXA255
# you must initialize SDRAM or leave this option off
working_area 0 0x5c000000 0x10000 nobackup

run_and_halt_time 0 30

#flash bank <driver> <base> <size> <chip_width> <bus_width> [driver_options..]

flash bank cfi 0x00000000 0x1000000 2 2 0