Please note that User Registration has been temporarily disabled due to a recent increase in automated registrations. If anyone needs an account, please request one here: RequestAccount. Thanks for your patience!--Wmat (talk)
Please email User:Wmat if you experience any issues with the Request Account form.

Difference between revisions of "APEX Bootloader"

From eLinux.org
Jump to: navigation, search
Line 12: Line 12:
 
  o Support for booting APEX from non-memory-mapped storage, e.g. NAND flash, OneNAND, I2C
 
  o Support for booting APEX from non-memory-mapped storage, e.g. NAND flash, OneNAND, I2C
  
 +
[http://wiki.buici.com/wiki/Apex_Bootloader Apex Project Page]
  
 
[[Category:Bootloaders]]
 
[[Category:Bootloaders]]

Revision as of 00:29, 13 September 2007

APEX is a boot loader for embedded systems. It was written to support the Sharp LH series of SystemOnChip processors though it has been ported to a few other ARM targets including the Samsung S3C24xx series.

o Easy to build. It depends only on shell utilities and GCC.
o Easy to configure. There is a single configuration file and it uses the linux-2.6 Kconfig infrastructure.
o Excellent dependency management. Uses Linux kernel Kbuild to optimally manage dependencies.
o Modular. Commands and drivers may be included or excluded by configuration.
o Supported targets: LH79520, LH79524, LH7A400, LH7A404, IXP42x (e.g. Linksys NSLU2), S3C24xx, and iMX31.
o Support for RARP IP configuration and TFTP transfers to the target.
o Filesystem drivers for FAT, EXT2, and JFFS2.
o Partition driver for FIS as used by Redboot.
o Small footprint. A limited feature version can be as small as 16KiB.
o Support for booting APEX from non-memory-mapped storage, e.g. NAND flash, OneNAND, I2C

Apex Project Page