Android Kernel Installation

From eLinux.org
Revision as of 23:30, 22 September 2010 by Tim Bird (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

How to use a new kernel with the emulator or on a product.

In general, this will be very product-specific.

With the G1/ADP1

On the ADP1, you can boot using a specific kernel using fastboot, which will send it to the board as part of the bootup sequence. Specify the kernel as one of the parameters to the 'fastboot boot' option. See http://www.gotontheinter.net/content/fastboot-cheat-sheet for details.

Installing a boot image

You can create a "boot" image directly, and install that to the boot or recovery flash partition manually. This can be done either using a running kernel or using fastboot.

See these instructions for doing that: http://android-dls.com/wiki/index.php?title=HOWTO:_Unpack,_Edit,_and_Re-Pack_Boot_Images

Also, you can install the kernel into a recovery image, and install the recovery image using the system recovery procedure.

With the emulator

You can specify the kernel to use with the emulator using the '-kernel' command line option.

There are some interesting notes about using the emulator without specifying a AVD file at: http://groups.google.com/group/android-platform/browse_thread/thread/591290fde1e9865a

On a board using an SDCARD

OMAP EVM

For an OMAP EVM, using the Android image available from Mistral, place a new uImage on the SDCARD at the root the vfat partition. The bootloader will run the commands (from where??) to load the uImage and boot it.

Note that for the OMAP EVM, you need to have the board configured to boot from sdcard, rather than from flash.