Difference between revisions of "Panda How to add Power Switch"

From eLinux.org
Jump to: navigation, search
Line 46: Line 46:
  
 
*  First few pins of J6   
 
*  First few pins of J6   
[[image:j6_detail2.jpg|600x]]
+
[[image:j6_detail3.jpg|800px]]
  
  
 
[[Category:PandaBoard]]
 
[[Category:PandaBoard]]

Revision as of 17:46, 4 May 2011

Introduction

  • The J6 expansion header on the PandaBoard allows for the addition of a power switch.

This is a Work In Progress, don't go by anything below this line.


Materials

These are the materials you will need in addition to your Pandaboard.


Header.jpg

Pinout

  • J6 Pinout

J6 detail1.jpg

Assembly

Here is what the header will look like when soldered to J6 of the Pandaboard.

  • Solder the header into the J6 pins closest to the WIFI module
  • Detail of the header soldered into J6

Board1.jpg


Notes

  • First few pins of J6

J6 detail3.jpg