Yocto Image for H3ULCB+Kingfisher M04

Jump to: navigation, search

hello Khuber,


Sorry, I noticed that I had used upstream dtb instead of KF BSP's one...

Thus, I confirmed again whether yocto can be booted or not.

As the result, I got kernel panic as same as you did.


I investigated the log, and noticed kernel is stopped at around rpc.

Below is a part of your log.

```

[ 1.574607] renesas-rpc ee200000.rpc0: using DMA read (dma0chan0)

[ 1.581125] Bad mode in Error handler detected on CPU1, code 0xbf000000 -- SError

```

I think it may be caused by a mismatch configuration for rpc between Android IPL and kernel .


Finally, I confirmed to boot yocto after I disabled rpc driver in kernel.

Here is patch of modification.

File:Rpc.patch

I hope that you can boot yocto as same as I do.


FYI:

note) If you are not going to use rpc, please ignore after this.

I found patch about RPC for IPL:

  1. https://github.com/CogentEmbedded/meta-rcar/blob/v3.21.0/meta-rcar-gen3-adas/recipes-bsp/arm-trusted-firmware/files/0001-plat-renesas-rcar-Make-RPC-secure-settings-optional.patch

If this patch is applied to Android IPL, Yocto may be booted without any modification.

However, I don't have build environment for android so that I cannot confirmed it.

00:55, 8 April 2020

Thank you Y.H., you are my hero!

I disabled RPC by adding DISABLE_RPC_ACCESS = "1" to my local.conf.

08:02, 9 April 2020