A13 OLinuXino-MICRO
Revision as of 06:02, 1 April 2013 by Matt Porter (talk | contribs) (Created page with " == JTAG support == The A13 OLinuXino-MICRO has JTAG support brought out to an unpopulated 6-pin header next to the headphone jack. Solder a piece of header strip and it's re...")
JTAG support
The A13 OLinuXino-MICRO has JTAG support brought out to an unpopulated 6-pin header next to the headphone jack. Solder a piece of header strip and it's ready to go.
Cabling
The table below shows the pinout for the proprietary JTAG header on the board. All pins are clearly silkscreened on the bottom of the board.
| A13 OLinuXino JTAG | Pin | JTAG Signal | ARM 20-pin JTAG | ARM 14-pin |
|---|---|---|---|---|
| GND | 1 | GND | 10 | 10 |
| TDO | 2 | TDO | 13 | 11 |
| TCK | 3 | TCK | 9 | 9 |
| TMS | 4 | TMS | 7 | 7 |
| TDI | 5 | TDI | 5 | 5 |
| 3.3V | 6 | 3.3V | 1 | 1 |
BDI-2000/3000
This config file can be used with a BDI configured with the ARM11/Cortex-An firmware and the standard BDI ARM/Xscale 20-pin JTAG cable.
