Difference between revisions of "Banana Pi"

From eLinux.org
Jump to: navigation, search
(New models in Banana Pi family)
Line 67: Line 67:
 
|}
 
|}
  
== New models in Banana Pi family ==
+
== Models of Banana Pi ==
  
 +
* [http://www.banana-pi.org/m1.html Banana Pi BPM-M1 Classic, dual-core]
 +
* [http://www.banana-pi.org/m1plus.html Banana Pi BPM-M1 Plus, dual-core]
 +
* [http://www.lemaker.org/article-43-1.html Banana Pro, dual-core]
 
* [http://www.banana-pi.org/m2.html Banana Pi BPM-M2, quad-core]
 
* [http://www.banana-pi.org/m2.html Banana Pi BPM-M2, quad-core]
 
* [http://www.banana-pi.org/m3.html Banana Pi BPM-M3, octa-core]
 
* [http://www.banana-pi.org/m3.html Banana Pi BPM-M3, octa-core]

Revision as of 09:07, 4 October 2015

Banana Pi BPI-M1 Classic
Banana Pi BPI-M1 Plus
Banana Pi BPI-M2
Banana Pi BPI-M3

Banana Pi is the generic name of a family of open source computer boards capable of running Linux and Android 4.4. The dual-core models featured an AllWinner A20 SoC with ARM Cortex-A7 CPU cores and 1GB of memory. Subsequent models feature the Allwinner quad-core Cortex-A7 A31S and octa-core A83T SoCs.

Linux on Allwinner SoC resources

Banana Pi Resources

Banana Pi Community

Note that Banana Pi has experienced some vendor and community partitioning as a result of design cloning and possible trademark disputes.

Specifications

This section refers to the original dual-core model of Banana Pi, "BPM-M1 Classic".

CPU A20 ARM® Cortex™-A7 Dual-Core
GPU ARM Mali400MP2 Complies with OpenGL ES 2.0/1.1
Memory (SDRAM) 1GB DDR3 (shared with GPU)
Onboard Storage SD (Max. 64GB) / MMC card slot UP to 2T on SATA disk
Onboard Network 10/100/1000 Ethernet RJ45 (optional USB WIFI Dongle)
Camera Input A CSI input connector allows for the connection of a designed camera module
Sound Input Mic
Video Outputs HDMI, CVBS , LVDS/RGB
Audio Output 3.5 mm Jack and HDMI
Power Source 5 volt via MicroUSB(DC In Only) and/or MicroUSB (OTG)
USB 2.0 Ports 2 (direct from Allwinner A20 chip)
Buttons Reset button: Next to MicroUSB connector

Power button: Next to Reset button

UBoot button (optional): Behind HDMI connector

GPIO(2X13) pin GPIO,UART,I2C bus,SPI bus with two chip selects,CAN bus,ADC,PWM,+3.3v,+5v,ground.
LED Power Status LED (Red)

Ethernet Status LED (Blue)

User Define LED (Green)

Remote IR

Models of Banana Pi

OS Support

  • Raspbian
  • Lubuntu
  • OpenSuse
  • Fedora
  • ArchLinux
  • Bananian
  • Android 4.4