Revision as of 11:15, 31 May 2013 by Alan o (talk | contribs) (First incomplete cut)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

BeagleBone Black

This page documents installation, use, maintenance, and software development using Linux on a BeagleBone.

Getting Started

[1] has a great started guide which covers the BeagleBone and BeagleBone Black. This guide covers steps from unboxing all the way though installing an image on the SD card (for BeagleBone), or installing a flasher image and flashing the eMMC (for BeagleBone Black).

Making an SD card the hard way

Angstrom BeagleBoard page contains pre built kernels, bootloaders, filesystems, and whole-disk images for the official Angstrom releases, as well as instructions for installation.

The Angstrom Distribution

The official distribution shipped with the BeagleBone is [2]. Angstrom is built upon [3], and has targets for many popular embedded Linux boards.

Building Angstrom from source

Documentation regarding building Angstrom from source can be found on the Angstrom page at the Angstrom website. For BeagleBone, use MACHINE=beaglebone

TODO: Also tell how to get from a built angstrom distro to something installed on the SD card.

Building just the kernel

To build just the kernel, run the following:

  MACHINE=beaglebone ./ bitbake virtual/kernel

TODO: tell where this kernel shows up and what to do with it (copy to SD card).

Build just the toolchain

TODO: Figure out how to actually do this (nobody seemed to know when I asked last time).

Downloading a prebuilt toolchain

Prebuilt toolchains can be downloaded from the Toolchains page. For BeagleBone, The armv7a-vfp-neon toolchains will work for the BeagleBone.

The Linux Kernel

The modern Linux kernels (version 3.8) for the BeagleBone Black (and also the modern kernel on the BeagleBone), is implemented and maintained as a set of patches ahead of the mainline kernel, along with a script to download a mainline kernel and patch it accordingly. This is the same kernel (mainline and patches) which is in the Angstrom build.

To Build a kernel, check out the beagleboard/kernel Github project, making sure to use branch 3.8. The contains exact steps for building the kernel and copying it to your BeagleBone.

The U-Boot Bootloader

The BeagleBone uses the [4] bootloader. TODO: What's the official u-boot to use, and how to build it? TODO: Where is the official uEnv.txt? TODO: Is there a list of uEnv.txt variables which work with the installed bootloader? TODO: How to set the HDMI resolution?

The Angstrom Linux Distribution

TODO install packages TODO upgrade distro TODO configure networking TODO links to some basic Unix/Linux resources TODO (plenty of other stuff could go here)

Software Development

Build software with native toolchian

Build software with a cross toolchain

Talking to hardware

       * DeviceTree and Capemgr
           * Example for each bus
               * Serial port
               * SPI
               * I2C
               * etc
   * PRU (optional?)