Difference between revisions of "CAN Bus"

From eLinux.org
Jump to: navigation, search
(SocketCAN Supported Controllers: add TI SoCs and ASCII protocol based devices)
(Overview: add SocketCAN devoted G+ page)
Line 14: Line 14:
  
 
http://en.wikipedia.org/wiki/CAN_bus
 
http://en.wikipedia.org/wiki/CAN_bus
 +
 +
[https://plus.google.com/u/0/117660856159215855502 SocketCAN News]
  
 
=== CAN Support in Linux ===
 
=== CAN Support in Linux ===

Revision as of 00:54, 28 January 2013

Overview

The CAN bus is an ISO standard bus for vehicles. It manages the Chassis Electrical System Control and is responsible for critical activities like engine electrical, and skid control. This system is also used to provide vehicle diagnostic information for maintenance. A multi-star configuration seems typical of this bus with a primary bus line that branches into sub bus lines at its extremities then attaches to multiple device nodes. Differential voltage is applied over twisted pair at 1.5 to 2.5V and 2.5 to 3.5V for noise resistant signaling. Bit rates up to 1 Mbit/s are possible at network lengths below 40 m. Decreasing the bit rate allows longer network distances (e.g., 500 m at 125 kbit/s).

(Jeremiah J. Flerchinger Source)

additional information can be found at:

http://en.wikipedia.org/wiki/CAN_bus

SocketCAN News

CAN Support in Linux

The Linux kernel supports CAN with the SocketCAN framework.

SocketCAN Supported Controllers

  • Microchip MCP251x
  • Atmel AT91 SoCs
  • ESD 331 CAN Cards
  • Philips SJA1000
  • Freescale MPC52xx SoCs
  • Bosch CC770
  • Intel AN82527
  • TIs SoCs
  • Serial/network devices utilizing ASCII protocol (slcan driver)