Connecting to B3

From eLinux.org
Revision as of 20:35, 4 September 2013 by Yoonghm (talk | contribs)
Jump to: navigation, search

Connecting via USB

  1. Plug in B3 via USB cable to a PC.

The POWER LED lit steadily. This will power the board and provide a development interface.

BeagleBone will boot from the on-board 2GB eMMC and operates as a flash drive within 10 seconds.

The LEDs blink in their default configurations

    • USR0 is configured at boot to blink in a heartbeat pattern
    • USR1 is configured at boot to light during microSD card accesses
    • USR2 is configured at boot to light during CPU activity
    • USR3 is configured at boot to light during eMMC accesses