Difference between revisions of "DaVinci USBHost 1.0"
m (USBHost 1.0 moved to DaVinci USBHost 1.0: doesn't fit naming scheme) |
Peter Huewe (talk | contribs) (Added to category DaVinci) |
||
(One intermediate revision by one other user not shown) | |||
Line 3: | Line 3: | ||
cd into your kernel lsp directory. | cd into your kernel lsp directory. | ||
− | Run make menuconfig. | + | Run |
+ | make menuconfig. | ||
Select drivers -> SCSI. | Select drivers -> SCSI. | ||
Line 21: | Line 22: | ||
Make sure the jumper by the USB port is in the right location for HOST mode (check manual). | Make sure the jumper by the USB port is in the right location for HOST mode (check manual). | ||
− | mkdir /usbdrive | + | mkdir /usbdrive |
insert your USB card reader | insert your USB card reader | ||
Line 27: | Line 28: | ||
mount your card using: | mount your card using: | ||
− | mount /dev/sdXX /usbdrive -o sync | + | mount /dev/sdXX /usbdrive -o sync |
where XX = a1, a2, a3, b1 etc.. | where XX = a1, a2, a3, b1 etc.. | ||
Enjoy! | Enjoy! | ||
+ | |||
+ | [[Category:Development Boards]] | ||
+ | [[Category:DaVinci]] |
Latest revision as of 21:55, 12 April 2011
USB Host Guide 1.0
cd into your kernel lsp directory.
Run
make menuconfig.
Select drivers -> SCSI.
Enable scsi disk support and enable Probs multiple LUN option.
Select drivers -> USB.
Enable Host-side USB.
Enable USB device filesystem.
Enable USB Mass Storage Device option.
Get the kernel onto your board in the usual way.
Make sure the jumper by the USB port is in the right location for HOST mode (check manual).
mkdir /usbdrive
insert your USB card reader
mount your card using:
mount /dev/sdXX /usbdrive -o sync
where XX = a1, a2, a3, b1 etc..
Enjoy!