Difference between revisions of "EVM input buttons"
SpaceMonkey (talk | contribs) |
m (Fix spelling of category) |
||
(3 intermediate revisions by 2 users not shown) | |||
Line 4: | Line 4: | ||
If you want to retain LED functionality, just send a command to turn off the LED prior to polling for the input status, otherwise you will read the output value rather than the switch! | If you want to retain LED functionality, just send a command to turn off the LED prior to polling for the input status, otherwise you will read the output value rather than the switch! | ||
+ | |||
+ | [[Image:Buttons.jpg]] | ||
+ | |||
+ | [[Category:DaVinci]] |
Latest revision as of 13:35, 27 October 2011
If you would like some input buttons for your evm you can solder some push buttons right onto the board.
Just connect them between the LEDs [REF CHECK WHICH SIDE OF LED!] and ground.
If you want to retain LED functionality, just send a command to turn off the LED prior to polling for the input status, otherwise you will read the output value rather than the switch!