File:ECE597SumoRobotPanels.svg

From eLinux.org
Revision as of 17:20, 25 July 2010 by Tomwm (talk | contribs) (A drawing of the panels that combine to form the sumo robot's chassis. This drawing was converted to DXF format and a water cutter used to cut the panels from aluminum scrap. Note that some minor changes were made to the )
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
Original file(SVG file, nominally 886 × 602 pixels, file size: 24 KB)

A drawing of the panels that combine to form the sumo robot's chassis. This drawing was converted to DXF format and a water cutter used to cut the panels from aluminum scrap. Note that some minor changes were made to the positioning of the motor mounts in the water cutter's proprietary software --- the holes are slightly misaligned and all are slightly (~1/16") too close to the front/rear of the robot.

To secure the corners, 1/8 inch aluminum bar was drilled and tapped for 4-40 screws. 1/4 inch aluminum angle was used to secure the top and bottom panels to the side panels (again with 4-40 screws), though more bar would have been superior. The electronics were secured to the top with standard standoffs.

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeThumbnailDimensionsUserComment
current17:20, 25 July 2010Thumbnail for version as of 17:20, 25 July 2010886 × 602 (24 KB)Tomwm (talk | contribs)A drawing of the panels that combine to form the sumo robot's chassis. This drawing was converted to DXF format and a water cutter used to cut the panels from aluminum scrap. Note that some minor changes were made to the
  • You cannot overwrite this file.

The following page links to this file:

Metadata