to replace unscrew the 2 parts, slide the head sink onto the part so the rails catch under the chip Tighten a little
Currently, NetBSD/sandpoint requires the use of Motorola's DINK32 ROM to load over a serial port. This means that there is no way to boot from a local disk or PCI device.
Supported processor cards
- mobo sandpoint/X4 with MPC8240
- CPUmodule Altimus X3 with either MPC755 or MPC7410
Other PMCs should work, but may need minor adjustments or more substantial work to support additional functionality.
- Asante Mac 10/100 PCI Rev A, part number 09-00169-01 (de) - Farallon Fast EtherTX 10/100, part number PN996L-TX (de) - SMC Etherpower II (9432TX) (epic) - SMC 83c170 (epic) - 3Com 3c905 (ex) - Intel EtherExpress PRO/10+ PCI LAN Adapter (fxp) - Realtek 8029 Ethernet (ne) - VIA Technologies VT86C926 (ne) - D-Link DFE-530TX+ (rtk) - Realtek 8139 (rtk) - Netgear FA-311 (sip) - Lite-On PNIC (tlp) - D-Link DFE-530TX (vr) - Many other PCI Ethernet interfaces, such as Tulip-compatible (de and tlp), 3Com (ep), SMC (epic), Intel (fxp), NE2000-compatible (ne), and Realtek (rtk)
- Adaptec PCI controllers 291x, 2920, 2930C, 294x, 295x, 39xx, 19160, 29160 and AIC-78xx (ahc) - AdvanSys ABP-940UW, ABP-970UW, ASB3940UW-00 SCSI host adapters (adw) - AdvanSys 1200[A,B], 9xx[U,UA] SCSI controller (adv) - AMD 53c974 (pcscp) - DPT SmartCache/SmartRAID (dpt) - NCR/Symbios 53C8xx (siop or esiop) - Many other PCI SCSI controllers should work, but no one has tried them - Most SCSI disk/tape/CD-ROM devices should work
- Promise Ultra66 (pciide) - Some other PCI IDE controllers should work, although no one has had much success - Most IDE disk/CD-ROM/ATAPI devices should work
- PCI audio cards, although none have been tested.
- Serial ports
- On-board serial ports (the modem and printer ports) (com0 and com1) - Some PCI serial ports should work, but no one has tried them
- PCI cards
- Most MI PCI cards should work, although very few have been tested with NetBSD/sandpoint http://www.NetBSD.org/support/hardware/pci.html
- Built-in PS/2 keyboard & mouse
- Built-in parallel
- Built-in floppy
- Built-in IDE
Supported boot devices
Currently, the only way to boot the system is with the DINK32 ROM monitor's serial download or a JTAG device.