Difference between revisions of "Hammer Board HOWTOS"

From eLinux.org
Jump to: navigation, search
Line 1: Line 1:
This is a place holder for the How-To section
+
This is the index for the How-To section
  
How to get an [[Enc28j60]] working on the Hammer board
+
[[How_to_Swtching_5V_Regulator]] for the Hammer Carrier
  
First you have to get an [[Enc28j60]], the following links may be usefull:
+
[[How_to_USB_Ethernet]] adapter for the Hammer board
  
*[http://www.sparkfun.com/commerce/product_info.php?products_id=765 SparkFun]
+
[[How_to_Enc28j60]] for the Hammer board
*[http://www.olimex.com/dev/enc28j60-h.html Olimex]
 
*[http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1335&dDocName=en022889 MicroChip]
 
*[http://microcontrollershop.com/product_info.php?cPath=98&products_id=1390 uC Pro's]
 
 
 
Next we will be soldering it on to the [Hammer_Carrier Hammer Carrier board]
 
 
 
We will need an aux 3.3V regulator as the ENC28J60-H can draw up to 250ma from its supply.
 
Make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.
 
 
 
Insert picture of the result
 
 
 
Insert picture of the wires soldered to the SPI, VccAux & Gnd points
 
 
 
Software driver info:
 
 
 
The Good  Kernel SPI API
 
  The Bad  &
 
    The Ugly  The current "driver"
 

Revision as of 09:13, 2 September 2007

This is the index for the How-To section

How_to_Swtching_5V_Regulator for the Hammer Carrier

How_to_USB_Ethernet adapter for the Hammer board

How_to_Enc28j60 for the Hammer board