Difference between revisions of "Hammer How to Enc28j60"
Line 23: | Line 23: | ||
| 1 | | 1 | ||
| 7 | | 7 | ||
− | | | + | | SPICLK0 |
|- | |- | ||
| MOSI | | MOSI | ||
| 2 | | 2 | ||
| 6 | | 6 | ||
− | | | + | | MOSI0 |
|- | |- | ||
| MISO | | MISO | ||
| 3 | | 3 | ||
| 5 | | 5 | ||
− | | | + | | MISO0 |
|- | |- | ||
| WOL | | WOL | ||
Line 43: | Line 43: | ||
| 5 | | 5 | ||
| 8 | | 8 | ||
− | | | + | | EINT10 |
|- | |- | ||
| CLKOUT | | CLKOUT | ||
Line 53: | Line 53: | ||
| 7 | | 7 | ||
| 11 | | 11 | ||
− | | | + | | GPH1 |
|- | |- | ||
| RST | | RST | ||
| 8 | | 8 | ||
| 9 | | 9 | ||
− | | | + | | nReset |
|- | |- | ||
| Ground | | Ground |
Revision as of 07:21, 11 September 2007
First you have to get an Enc28j60, the following links may be usefull:
Next we will be soldering it on to the Hammer_Carrier
We will use the 3.3V regulator of the Hammer_Carrier, but you already need to have done the How_to_Swtching_5V_Regulator
Wire the Olimex Enc28j60 board to the Hammer_Carrier pins as follows:
ENC28J60 | Pin | Pin | Hammer |
---|---|---|---|
SCK | 1 | 7 | SPICLK0 |
MOSI | 2 | 6 | MOSI0 |
MISO | 3 | 5 | MISO0 |
WOL | 4 | N/C | |
INT | 5 | 8 | EINT10 |
CLKOUT | 6 | N/C | |
CS | 7 | 11 | GPH1 |
RST | 8 | 9 | nReset |
Ground | 9 | GND | Ground |
Vdd | 10 | TP9 | +3.3V |
Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.
Software driver info:
The Good Kernel SPI API The Bad & The Ugly The current "driver"