Difference between revisions of "Hammer How to Enc28j60"
KenMcGuire (talk | contribs) |
(Removed link to deleted page.) |
||
| Line 9: | Line 9: | ||
We will use the 3.3V regulator of the [[Hammer_Carrier]], but you already need to have | We will use the 3.3V regulator of the [[Hammer_Carrier]], but you already need to have | ||
| − | done the | + | done the Hammer_How_to_Swtching_5V_Regulator. |
Revision as of 18:27, 27 January 2010
First you have to get an Enc28j60, the following links may be usefull:
Next we will be soldering it on to the Hammer_Carrier
We will use the 3.3V regulator of the Hammer_Carrier, but you already need to have done the Hammer_How_to_Swtching_5V_Regulator.
Wire the Olimex Enc28j60 board to the Hammer_Carrier pins as follows:
| ENC28J60 | Pin | Pin | Hammer |
|---|---|---|---|
| SCK | 1 | 7 | SPICLK0 |
| MOSI | 2 | 6 | MOSI0 |
| MISO | 3 | 5 | MISO0 |
| WOL | 4 | N/C | |
| INT | 5 | 8 | EINT10 |
| CLKOUT | 6 | N/C | |
| CS | 7 | 11 | GPH0 |
| RST | 8 | 9 | nReset |
| Ground | 9 | GND | Ground |
| Vdd | 10 | TP9 | +3.3V |
Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.
I used a socket strip that keeps the board about 1/2 inch above the Hammer_Carrier prototype area. This may be important because the PIC chip on the ENC28j60 gets quite warm.
Software driver info:
The Good Kernel SPI API
The Bad The 2.4 driver
The Ugly The current 2.6 "driver" included in the kernel patch at Hammer_Board_Software
The driver may either be compiled as a module, or as a part of the kernel. If you are running short on space for the kernel, it's probably advisable to compile it as module.
The SPI channel that is reserved for the ethernet on the Hammer Carrier board is SPI0. The MMC interface uses SPI1. The current UBE driver may need to be re-configured if you are going to use anything but the Hammer Carrier.
