Hammer How to Enc28j60
Revision as of 10:13, 2 September 2007 by KenMcGuire (talk | contribs)
First you have to get an Enc28j60, the following links may be usefull:
Next we will be soldering it on to the Hammer_Carrier
We will use the 3.3V regulator of the Hammier Carrrier, but you already need to have done the How_to_Swtching_5V_Regulator
Also make sure that your 5V main power supply can supply the Hammer as well as the ENC28J60-H.
Insert picture of the result
Insert picture of the wires soldered to the SPI, VccAux & Gnd points
Software driver info:
The Good Kernel SPI API The Bad & The Ugly The current "driver"