Difference between revisions of "Hammer How to Reflash Apex and kernel"

From eLinux.org
Jump to: navigation, search
(Reformatted to look a bit nicer)
m (typo in where the zImage is found /arch/arm not /arch/arn)
Line 3: Line 3:
 
=== Flashing a new kernel (zImage) ===
 
=== Flashing a new kernel (zImage) ===
  
You'll find the zImage file in the linux-2.6.22/arch/arn/boot directory.
+
You'll find the zImage file in the linux-2.6.22/arch/arm/boot directory.
  
 
  apex> xr 0x30008000  <=== This is the address that the flash base kernel is copied to by apex on powerup>
 
  apex> xr 0x30008000  <=== This is the address that the flash base kernel is copied to by apex on powerup>

Revision as of 09:14, 2 May 2009

These instructions assume that apex has been configured for a 1024k kernel region

Flashing a new kernel (zImage)

You'll find the zImage file in the linux-2.6.22/arch/arm/boot directory.

apex> xr 0x30008000  <=== This is the address that the flash base kernel is copied to by apex on powerup>
< send zImage via xmodem>
apex> erase nor:256k+1024k
apex> copy 0x30008000+1024k nor:256k
1048576 bytes transferred
apex> boot  <this will boot the newly flashed kernel with the existing rootfs>

Flashing a new rootfs

You'll find the rootfs.arm.ext2.gz file in the buildroot/binaries/Hammer directory.

apex> xr 0x30800000  <=== This is the address that the flash base rootfs is copied to by apex on powerup>
<send rootfs.arm.ext2.gz via xmodem>
apex> erase nor:1280k+1024k
apex> copy 0x30800000+1024k nor:1280k
1048576 bytes transferred
apex> boot   <this will boot the existing kernel with the newly flashed rootfs>

Flashing a new bootloader (apex)

apex> xr 0x30008000
< send apex.bin via xmodem>
apex> erase nor:0x00+256k   <<<yes this is correct, the 256k is intended to erase the entire block!
apex> copy 0x30008000+128k nor:0x00
131072 bytes transferred

then press reset to run the newly flashed apex, do not type boot