Difference between revisions of "Jetson/TX1 WiFi Access Point"

From eLinux.org
Jump to: navigation, search
(Created page with "Jetson TX1's WiFi controller can be run in Access Point (AP) hot-spot mode, enabling TX1 to host it's own WiFi network. == Setting Broadcom op_mode == To enable SSID broadca...")
 
m
 
Line 3: Line 3:
 
== Setting Broadcom op_mode ==
 
== Setting Broadcom op_mode ==
  
To enable SSID broadcast, the driver’s op_mode parameter has to be set to 2.
+
To enable SSID broadcast, the driver’s <source lang="c" enclose="none">op_mode</source> parameter has to be set to 2.
  
 
This can be set in two ways:
 
This can be set in two ways:
# Manually via /sys/module/bcmdhd/paramters/op_mode node:
+
# Manually via <source lang="c" enclose="none">/sys/module/bcmdhd/paramters/op_mode</source> node:
 
::::<code>$ echo 2 > /sys/module/bcmdhd/parameters/op_mode</code>
 
::::<code>$ echo 2 > /sys/module/bcmdhd/parameters/op_mode</code>
 
# Add the following line to <source lang="c" enclose="none">/etc/modprobe.d/bcmdhd.conf</source>:
 
# Add the following line to <source lang="c" enclose="none">/etc/modprobe.d/bcmdhd.conf</source>:

Latest revision as of 13:17, 17 June 2016

Jetson TX1's WiFi controller can be run in Access Point (AP) hot-spot mode, enabling TX1 to host it's own WiFi network.

Setting Broadcom op_mode

To enable SSID broadcast, the driver’s op_mode parameter has to be set to 2.

This can be set in two ways:

  1. Manually via /sys/module/bcmdhd/paramters/op_mode node:
$ echo 2 > /sys/module/bcmdhd/parameters/op_mode
  1. Add the following line to /etc/modprobe.d/bcmdhd.conf:
options bcmdhd op_mode=2

Using hostapd

See the following guide to using hostapd service for running the Access Point: https://seravo.fi/2014/create-wireless-access-point-hostapd

Here is also a forum thread discussing the topic: https://devtalk.nvidia.com/default/topic/910608/setting-up-wifi-access-point-on-tx1/