Difference between revisions of "Minnowboard:Bob Lure"

From eLinux.org
Jump to: navigation, search
(Bob Lure wiki page)
 
(Features)
 
(4 intermediate revisions by one other user not shown)
Line 7: Line 7:
  
 
= Features =
 
= Features =
Breakout for all low speed signals
+
* 62.25mm x 62.25mm (2.45" x 2.45")
* i2c
+
* Connector A99192TR-ND Female (digikey part number)
* spi
+
* Mated height 6mm (when mated with 5mm base)
* gpio
+
* Single hole for mounting point
* UARTs
+
* Breakout for all low speed signals
* usb host
+
** i2c
 +
** spi
 +
** gpio
 +
** UARTs
 +
** usb host
 +
** +5V
 +
** +3.3V
 +
** Ground
 +
 
 
= References =
 
= References =
  
* [http://www.elinux.org/Minnowboard:Expansion_Interfaces MinnowBoard Expansion Interfaces]
+
* [http://www.elinux.org/Minnowboard:Expansion_Interfaces MinnowBoard Expansion Port Interfaces]
  
 
= Design =
 
= Design =
 +
* [[media:Lure-bob-sch.pdf|Schematic]]
 +
* [[media:Lure-bob.pdf|Fabrication document]]
 +
* [[media:Lure-bob-rev01.zip|Gerber]]
  
 
= Software =
 
= Software =

Latest revision as of 21:27, 24 July 2013

Description

Break-out-board or the 'BOB' Lure is a small accessory board that is primarily intended for use with the MinnowBoard. It provides a convenient way to access the different interfaces on the MinnowBoard expansion port.

Bob-lure-closeup.jpg Bob-lure-top.jpg Bob-lure-front.jpg Bob-lure-back.jpg Bob-lure-side.jpg


Features

  • 62.25mm x 62.25mm (2.45" x 2.45")
  • Connector A99192TR-ND Female (digikey part number)
  • Mated height 6mm (when mated with 5mm base)
  • Single hole for mounting point
  • Breakout for all low speed signals
    • i2c
    • spi
    • gpio
    • UARTs
    • usb host
    • +5V
    • +3.3V
    • Ground

References

Design

Software

  • TBD