Difference between revisions of "Minnowboard:MaxLures"
(→Calamari Lure) |
|||
Line 2: | Line 2: | ||
= Lures In production (currently available) = | = Lures In production (currently available) = | ||
+ | |||
+ | These are lures that are currently available, and obtainable in a pre-built state. | ||
+ | |||
== Calamari Lure == | == Calamari Lure == | ||
{| width="100%" | {| width="100%" | ||
Line 166: | Line 169: | ||
|} | |} | ||
− | = | + | = Ready to Build = |
+ | |||
+ | These are lures that are functionally complete, but are not being (or not currently) in production and/or available to buy. To be in this state the lures need to be in a state where an individual has enough information to fully build these on their own. | ||
+ | |||
== Cuttle(bone) Lure == | == Cuttle(bone) Lure == | ||
{| width="100%" | {| width="100%" | ||
Line 191: | Line 197: | ||
**Project files on [https://github.com/ka6sox/Cuttlebone_Lure Github] | **Project files on [https://github.com/ka6sox/Cuttlebone_Lure Github] | ||
|} | |} | ||
+ | |||
+ | = Planned Lures = | ||
+ | |||
+ | These are lures that are either in the planning or early design stages and are not ready for production. | ||
+ | |||
+ | = Retried = | ||
+ | |||
+ | These are lures that do not have build files available, but information pertaining to them is still pertinent. |
Revision as of 16:49, 16 March 2015
Minnowboard Max Lure Information
Contents
Lures In production (currently available)
These are lures that are currently available, and obtainable in a pre-built state.
Calamari Lure
Break out board intended mainly for testing gpio and low speed interfaces, as
|
|||
Jetsam Lure
mPCI-E break out board
|
|||
Flotsam Lure
mSATA break out board
|
|||
Prototype Lure
Generic Prototype Area on 0.1" grids
|
|||
IDP JTAG Lure
Intel IDP JTAG lure
|
|||
Ready to Build
These are lures that are functionally complete, but are not being (or not currently) in production and/or available to buy. To be in this state the lures need to be in a state where an individual has enough information to fully build these on their own.
Cuttle(bone) Lure
Adapter from Low Speed Connector I/O (I2C,I2S,UARTs,SPI,GPIO) to BeagleBone * Capes. Works with a variety of Capes but not all.
|
|||
|
Planned Lures
These are lures that are either in the planning or early design stages and are not ready for production.
Retried
These are lures that do not have build files available, but information pertaining to them is still pertinent.