Difference between revisions of "R-Mobile/Boards/APE6-EVM"

From eLinux.org
Jump to: navigation, search
(Use stable reference to my board-farm branch)
Line 73: Line 73:
|X8 pin 28
|X8 pin 28
|Samtec QTE-020
|Samtec QTE-020
|Needs [https://git.kernel.org/pub/scm/linux/kernel/git/geert/renesas-drivers.git/commit/?h=topic/board-farm&id=379debff99d5fdfd190d3442424af09bbabeae43 ARM: dts: ape6evm: Enable PORT1 for wake-up]
|Needs ''ARM: dts: ape6evm: Enable PORT1 for wake-up'' from [https://git.kernel.org/pub/scm/linux/kernel/git/geert/renesas-drivers.git/log/?h=topic/board-farm renesas-drivers#topic/board-farm]

Revision as of 06:18, 21 May 2019


This is the Wiki for the Renesas R-Mobile APE6 APE6-EVM board. Refer to the R-Mobile page for information about Renesas' R-Mobile SoC family.

Serial Console

Use a micro-USB cable to connect to "Console". Serial settings are 115200 8N1.

Booting Linux

 * Kernel config: shmobile_defconfig
 * Kernel image: arch/arm/boot/uImage
 * DTB: arch/arm/boot/dts/r8a73a4-ape6evm.dtb

Create a uImage:

make LOADADDR=0x40008000 uImage

U-Boot boot command:

tftp 40f00000 r8a73a4-ape6evm.dtb 
tftp 41000000 uImage 
bootm 41000000 - dtb 40f00000



The system can be suspended using:

echo mem > /sys/power/state

Wake-Up Sources

Suspend-to-RAM supports the following wake-up sources:

  • gpio-keys: Wake-up using push button S16.
  • sh-sci (Serial): Disabled by default

Remote Control

Operation Signal A Pin A Signal B Pin B Connector needed Comments
Reset JTAG nSRST X12 pin 15 GND X12 pin 16 2-pin female Mini-PV nSRST is an 1.8V signal!
Wake-Up PORT1/DU0_DR1 X8 pin 16 GND X8 pin 28 Samtec QTE-020 Needs ARM: dts: ape6evm: Enable PORT1 for wake-up from renesas-drivers#topic/board-farm

Run U-Boot from JTAG

Start openocd, one can use the similar and upstream Stout board file.

openocd -f interface/ftdi/flyswatter2.cfg -f board/renesas_stout.cfg -c 'adapter_khz 300'

Halt the target, load U-Boot and jump to it.

load_image /path/to/uboot.bin 0xe8200000
resume 0xe8200000