Difference between revisions of "R-Mobile/Boards/KZM-A9-GT"
< R-Mobile
(Add Remote Control) |
m (Reduce section levels) |
||
Line 1: | Line 1: | ||
{{TOC right}} | {{TOC right}} | ||
− | + | = Introduction = | |
− | |||
− | |||
This is the Wiki for the Renesas SH-Mobile AG5-based Kyoto Microcomputer Co. KZM-A9-GT board. | This is the Wiki for the Renesas SH-Mobile AG5-based Kyoto Microcomputer Co. KZM-A9-GT board. | ||
Refer to the [[R-Mobile]] page for information about Renesas' SH-Mobile SoC family. | Refer to the [[R-Mobile]] page for information about Renesas' SH-Mobile SoC family. | ||
− | + | = Serial Console = | |
Use a mini-USB cable to connect to "CN22". | Use a mini-USB cable to connect to "CN22". | ||
Serial settings are 115200 8N1. | Serial settings are 115200 8N1. | ||
− | + | = Booting Linux = | |
* Kernel config: shmobile_defconfig | * Kernel config: shmobile_defconfig | ||
Line 31: | Line 29: | ||
</pre> | </pre> | ||
− | + | = Remote Control = | |
{| class="wikitable" | {| class="wikitable" |
Revision as of 08:23, 10 November 2017
Introduction
This is the Wiki for the Renesas SH-Mobile AG5-based Kyoto Microcomputer Co. KZM-A9-GT board. Refer to the R-Mobile page for information about Renesas' SH-Mobile SoC family.
Serial Console
Use a mini-USB cable to connect to "CN22". Serial settings are 115200 8N1.
Booting Linux
* Kernel config: shmobile_defconfig * Kernel image: arch/arm/boot/zImage.dtb * DTB: arch/arm/boot/dts/sh73a0-kzm9g.dtb
Create a zImage with appended DTB:
make zImage dtbs cat arch/arm/boot/zImage arch/arm/boot/dts/sh73a0-kzm9g.dtb > arch/arm/boot/zImage.dtb
U-Boot boot command:
tftp 0x43000000 kzm9g/zImage.dtb bootz
Remote Control
Operation | Signal A | Pin A | Signal B | Pin B | Connector needed | Comments |
Reset | JTAG nSRST | CN1 pin 15 | GND | CN1 pin 16 | 2-pin female Mini-PV | nSRST is an 1.8V signal! |
Wake-Up | NMI | SW6 | GND | SW6 | - | Needs soldering |