The Tadpole Lure is a low cost "Micro-Lure" design that providing a single RGB LED and a breakout/prototype area.
- 3 2N3906 PNP Transistors
- 1 RGB LED
- 1 12 Ohm 1/8 Resistor
- 2 68 Ohm 1/8 Resistors
- 3 4.7k Ohm 1/8 Resistors
- 1 2x13 0.1" Female Connector
- 1 PCB
To assemble the Tadpole Lure, a soldering iron (15Watt to 30Watt), some solder, and a pair of wire cutters.
R1 12 Ohm Resistor
There is a single resistor with the color code BROWN-RED-BLACK. This one is used for the resistor position marked R1.
R2/R3 68 Ohm Resistors
There are two resistors with the color code BLUE-GREY-BLACK. These are used for resistor positions marked R2 and R3.
R4/R5/R6 4.7K Ohm Resistors
There are three resistors with the color code YELLOW-VIOLET-RED. These are used for the resistor positions marked R4, R4 and R5.
The single RGB LED in the kit is mounted with the longest lead as the second hold from the side with a flat edge. The LED package has a flat side. The flat side is matched up with the white line marking on the PCB.
Three 2N3906 PNP transistors are included with the kit. Each transistor is mounted on the PCB with the flat side of the transistor matching the markings on the PCB.
The 2 row by 13 pin connector is mounted to the bottom of the PCB. The connector has a piece of plastic marking the "key side". The "key side" of the connector points to the outside of the PCB.