View source for Talk:R-Car/Boards/Salvator-X

From eLinux.org
Jump to: navigation, search

Contents

Thread titleRepliesLast modified
Failed to DRAM initialize002:15, 10 October 2019
Flashing of the Salvatore-X with poky images023:35, 25 June 2017
About contribution of a question105:44, 30 September 2016

Failed to DRAM initialize

Hi,

I followed the Yocto build and flashing procedure for H3 Salvator-x. However I get the following problem. I enabled some debug messages in boot_init_dram.c

SW7 is set to ‘cold boot’ It seems to fail the pi_training_go() test

[ 0.000169] NOTICE: BL2: R-Car Gen3 Initial Program Loader(CA53) Rev.1.0.21 [ 0.005745] NOTICE: BL2: PRR is R-Car H3 Ver.3.0 [ 0.010421] NOTICE: BL2: Board is Salvator-XS Rev.1.0 [ 0.015542] NOTICE: BL2: Boot device is HyperFlash(160MHz) [ 0.021063] NOTICE: BL2: LCM state is CM [ 0.025110] NOTICE: BL2: AVS setting succeeded. DVFS_SetVID=0x53 [ 0.031093] NOTICE: BL2: CH0: 0x400000000 - 0x480000000, 2 GiB [ 0.036964] NOTICE: BL2: CH1: 0x500000000 - 0x580000000, 2 GiB [ 0.042849] NOTICE: BL2: CH2: 0x600000000 - 0x680000000, 2 GiB [ 0.048733] NOTICE: BL2: CH3: 0x700000000 - 0x780000000, 2 GiB [ 0.054659] NOTICE: BL2: DDR3200(rev.0.33)NOTICE: Start [ 0.060116] NOTICE: init_ddr:0 [ 0.073840] NOTICE: init_ddr:1 [ 0.075791] NOTICE: init_ddr:2 [ 0.078615] NOTICE: [COLD_BOOT]NOTICE: init_ddr:3 [ 0.084204] NOTICE: init_ddr:4 [ 0.087476] NOTICE: init_ddr:5 [ 0.089849] NOTICE: init_ddr:6 [ 0.093275] NOTICE: init_ddr:7 [ 0.544304] NOTICE: ..1 [ 0.545360] NOTICE: BL2: Failed to DRAM initialize (-1). [ 5.007803] ERROR: [ 5.008597] ERROR: BL2: System WDT overflow, occurboot_init_dram.ced address is 0xe6312d78

Kind Regards, Declan

02:15, 10 October 2019

Flashing of the Salvatore-X with poky images

You do not have permission to edit this page, for the following reasons:

  • The action you have requested is limited to users in the group: Users.
  • You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.

You can view and copy the source of this page.

 

Return to Thread:Talk:R-Car/Boards/Salvator-X/Flashing of the Salvatore-X with poky images.

About contribution of a question

No one seems to be contributing. Should a question be contributed here?

Is it limited to a question in English?

ryuohno (talk)02:37, 30 September 2016

Sure, you can submit questions here. Hopefully the authors of the page content watch it. If you don't get a response, you can always email the content authors directly and point them at your question here. The wiki is English only.

Thanks

Wmat (talk)05:44, 30 September 2016