simple Kudos thread!

Jump to: navigation, search
Revision as of 12 December 2014 at 20:41.
The highlighted comment was created in this revision.

Thank you. Worked beautifully. And so simple!

    08:19, 8 January 2014

    I have tried this procedure but my Beaglebone Black (BBB) does not boot from the microSD, just from the on-board eMMC. I have limited experience with Linux-based systems and so i am sure I am doing, or not, something simple. I am using a rev A5C BBB with a 4GB FAT32 micrSD. Any pointers will be gratefully received. JohnG

      11:28, 12 February 2014
       

      I'm having the same issue as jgainsborough.

      I formatted a 4GB SDHC as FAT32, extracted the zip to it, inserted into powered-off BBB, held down USER/BOOT applied power, and waited. Never saw any lights other than the power light. Have tried many times, holding down USER/BOOT for as long as 30 seconds.

      Have tried with USB and with power supply. Same behavior. Board boots runs fine from internal memory.

        14:48, 16 February 2014
         

        The page neglects to mention that the partition on the SD must be marked active in order to be booted from when you hold down the USER/BOOT button.

          00:47, 21 February 2014
            11:09, 12 November 2014

            I had to hold down the S2 (USER/BOOT) button near the microSD card, while applying power to the board (by plugging in USB cable) in order to boot this firmware and extract the eMMC image. Pressing RESET while holding the S2 button did not work. After several seconds, I released the S2 button and then the LEDs started blinking. It seems the boot sequence doesn't proceed while S2 is being held down.

              13:41, 12 December 2014