Difference between revisions of "Thread:Talk:BeagleBone Black Extracting eMMC contents/simple Kudos thread!/reply (5)"

From eLinux.org
Jump to: navigation, search
 
m
Line 1: Line 1:
 
I had to hold down the S2 (USER/BOOT) button near the microSD card, while applying power to the board (by plugging in USB cable) in order to boot this firmware and extract the eMMC image.  Pressing RESET while holding the S2 button did not work.  After several seconds, I released the S2 button and then the LEDs started blinking.  It seems the boot sequence doesn't proceed while S2 is being held down.
 
I had to hold down the S2 (USER/BOOT) button near the microSD card, while applying power to the board (by plugging in USB cable) in order to boot this firmware and extract the eMMC image.  Pressing RESET while holding the S2 button did not work.  After several seconds, I released the S2 button and then the LEDs started blinking.  It seems the boot sequence doesn't proceed while S2 is being held down.
 +
 +
Edit: A further test shows that holding the S2 button for too long (15+ seconds) causes the board to turn off.

Revision as of 13:57, 12 December 2014

I had to hold down the S2 (USER/BOOT) button near the microSD card, while applying power to the board (by plugging in USB cable) in order to boot this firmware and extract the eMMC image. Pressing RESET while holding the S2 button did not work. After several seconds, I released the S2 button and then the LEDs started blinking. It seems the boot sequence doesn't proceed while S2 is being held down.

Edit: A further test shows that holding the S2 button for too long (15+ seconds) causes the board to turn off.