simple Kudos thread!

Jump to: navigation, search

I had to hold down the S2 (USER/BOOT) button near the microSD card, while applying power to the board (by plugging in USB cable) in order to boot this firmware and extract the eMMC image. Pressing RESET while holding the S2 button did not work. After several seconds, I released the S2 button and then the LEDs started blinking. It seems the boot sequence doesn't proceed while S2 is being held down.

13:41, 12 December 2014

Wish I'd noticed all these comments earlier. When in doubt, you might drop a note to http://beagleboard.org/discuss.

08:36, 6 February 2015