How to connect Starter Kit to Kingfisher and use Starter Kit's JTAG I/F

Jump to: navigation, search

You do not have permission to edit this page, for the following reasons:

  • The action you have requested is limited to users in the group: Users.
  • You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.

You can view and copy the source of this page.

 

Return to Thread:Talk:R-Car/Boards/Kingfisher/How to connect StarterKit to Kingfisher and use StarterKit's JTAG I/F.

I think the problem is that the TMS_18 signal is connected to GND. As one method, cutting the signal of SK seems to be able to avoid the problem. However, I think that it is very difficult to cut short distances from other signals(for me at least).

Anyway, please give me time to cut and confirm.

Ygohda (talk)‎19:14, 22 February 2018

Thank you for your response.
I will consider the correspondence.

ryuohno (talk)

‎21:27, 27 February 2018

I cut the signal of SK. Please refer to the picture on the back side of SK. 

File:SK TMS18.zip

Then, I connected SK and M04 KF and confirmed that JTAG started up.

Note: Cutting the signal is very difficult. I can not recommend it.

Ygohda (talk)‎21:02, 4 March 2018

Thank you for confirmation.

Wow! You are good with your hands!
I certainly think it is difficult to cut this.

ryuohno (talk)

‎01:55, 5 March 2018
 
 
 
 
Retrieved from "https://elinux.org/Thread:Talk:R-Car/Boards/Kingfisher/How_to_connect_StarterKit_to_Kingfisher_and_use_StarterKit%27s_JTAG_I/F#How_to_connect_Starter_Kit_to_Kingfisher_and_use_Starter_Kit.27s_JTAG_I.2FF_3486"