How to connect Starter Kit to Kingfisher and use Starter Kit's JTAG I/F
← Thread:Talk:R-Car/Boards/Kingfisher/How to connect StarterKit to Kingfisher and use StarterKit's JTAG I/F
I am using Kingfisher (SBEV-RCAR-KF-M04(Advanced Model)).
With Starter Kit connected to M04, Kingfisher manufacturer taught that Starter Kit's JTAG I/F can not be used.
However, by correcting the circuit on Starter Kit side, he taught him that Starter Kit's JTAG I/F can be used even when Starter Kit is connected to M04.
Please tell me about Starter Kit circuit correction contents necessary to use Starter Kit's JTAG I/F with Starter Kit connected to M04.
You do not have permission to edit this page, for the following reasons:
- The action you have requested is limited to users in the group: Users.
- You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.
You can view and copy the source of this page.
Return to Thread:Talk:R-Car/Boards/Kingfisher/How to connect StarterKit to Kingfisher and use StarterKit's JTAG I/F/reply.
Thank you for your response.
I will consider the correspondence.
I cut the signal of SK. Please refer to the picture on the back side of SK.
Then, I connected SK and M04 KF and confirmed that JTAG started up.
Note: Cutting the signal is very difficult. I can not recommend it.