Can't Modify U-Boot Environment Variables on Updated Firmware

Jump to: navigation, search

I'm sorry. The log was completely the same halfway. Have you updated all the files? 

- bootparam_sa0.srec
- bl2-h3ulcb.srec
- cert_header_sa6.srec
- bl31-h3ulcb.srec
- tee-h3ulcb.srec
- u-boot-elf.srec

Ygohda (talk)

‎18:50, 18 July 2017

You do not have permission to edit this page, for the following reasons:

  • The action you have requested is limited to users in the group: Users.
  • You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.

You can view and copy the source of this page.

Return to Thread:Talk:R-Car/Boards/Yocto-Gen3/Can't Modify U-Boot Environment Variables on Updated Firmware/reply (5).

Yes, /tmp/deploy/images/h3ulcb is correct path. Please refer to the No13 of http://elinux.org/R-Car/Boards/Yocto-Gen3#Building_the_BSP_for_Renesas_H3ULCB.2C_M3ULCB.

All updating methods are described below. http://elinux.org/R-Car/Boards/H3SK#Flashing_firmware Could you try again?

If "u-boot" still doesn't start up please attach the log when flashing the firmware.

Ygohda (talk)

‎04:03, 21 July 2017

Rebuilding the whole thing from scratch worked. Something must have gone wrong in the initial build because the .dtb file sizes between the two builds were off by a few hundred bytes.

Eli.sherman (talk)

‎23:38, 22 July 2017
 
 
 
Retrieved from "https://elinux.org/Thread:Talk:R-Car/Boards/Yocto-Gen3/Can%27t_Modify_U-Boot_Environment_Variables_on_Updated_Firmware/reply_(4)#Can.27t_Modify_U-Boot_Environment_Variables_on_Updated_Firmware_3241"