I2C errors appeared with multiple usb devices
← Thread:Talk:R-Car/Boards/Yocto-Gen3/I2C errors appeared with multiple usb devices/reply
You do not have permission to edit this page, for the following reasons:
- The action you have requested is limited to users in the group: Users.
- You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.
You can view and copy the source of this page.
As a result of our confirmation again, it can be reproduced, even if the USB device is not connected. Let me share the reproduction the scenario below. In addition, I used another board butI2C error is still reproduced.
[ Reproduce environment ]
- Renesas bsp 3.15 - Rcar M3 StarterKit + KF-M06 - CMOS Camera OV5642
https:// www.aliexpress.com/item/OV5642-5-Million-High-Sensitivity-Camera-Module-Image-Sensor-Module-Manual-Fine-tuning-with-JPEG-Interface/32909308847.html Connected CMOS Camera to CN 29 on KF-M06.
- capture command
Customized based on V4L2 video capture example in here. https:// linuxtv.org/downloads/v4l-dvb-apis-new/uapi/v4l/capture.c.html please see the attached file. # capture -d /dev/video0 -F -f rgb32 -L 0 -T 0 -W 12800 -H 720 -c 1000 -t 60 -z
[ 1491.549362] i2c-rcar e66d8000.i2c: error -11 : f
[ 1443.614690] i2c-rcar e66d8000.i2c: error -110 : 3
When capture command was executed, I2C bus error occurs probability as below. pattern1: 3/10. pattern2: 4/10.
Your feedback would be welcome. Thanks
I confirmed but did not reproduce.(0/20)
root@m3ulcb:~# dmesg|grep ov5642 [ 2.583901] ov5642 22-003c: Chip ID 0x5642 detected root@m3ulcb:~# capture -d /dev/video0 -F -f rgb32 -L 0 -T 0 -W 1280 -H 720 -c 1000 -t 60 -z fb0 Fixed Info: @ 0x57400000, len=8294400, line=7680 bytes, Geometry - 1280 x 800, 32 bpp /dev/video0 FPS: 29.1 (snip) /dev/video0 FPS: 29.1 root@m3ulcb:~#
- M3 SK (Connected: HDMI, Serial(cn12), Ether(cn7))
- KF M06(Connected: CMOS camera(cn29))