I2C errors appeared with multiple usb devices
← Thread:Talk:R-Car/Boards/Yocto-Gen3/I2C errors appeared with multiple usb devices/reply
Hi Can we reproduce this phenomenon if we don't use USB Wifi? M3 USB2.0(CN5) <---> USB HUB <---> USB MEMORY * 2 and USB mouse dongle KF-M06(CN29) <---> CMOS camera(ov5642)
I cannot reproduce.(0/20) Could you try it on another KF board?
As a result of our confirmation again, it can be reproduced, even if the USB device is not connected. Let me share the reproduction the scenario below. In addition, I used another board butI2C error is still reproduced.
[ Reproduce environment ]
- Renesas bsp 3.15 - Rcar M3 StarterKit + KF-M06 - CMOS Camera OV5642
https:// www.aliexpress.com/item/OV5642-5-Million-High-Sensitivity-Camera-Module-Image-Sensor-Module-Manual-Fine-tuning-with-JPEG-Interface/32909308847.html Connected CMOS Camera to CN 29 on KF-M06.
- capture command
Customized based on V4L2 video capture example in here. https:// linuxtv.org/downloads/v4l-dvb-apis-new/uapi/v4l/capture.c.html please see the attached file. # capture -d /dev/video0 -F -f rgb32 -L 0 -T 0 -W 12800 -H 720 -c 1000 -t 60 -z
[ 1491.549362] i2c-rcar e66d8000.i2c: error -11 : f
[ 1443.614690] i2c-rcar e66d8000.i2c: error -110 : 3
When capture command was executed, I2C bus error occurs probability as below. pattern1: 3/10. pattern2: 4/10.
Your feedback would be welcome. Thanks
I confirmed but did not reproduce.(0/20)
root@m3ulcb:~# dmesg|grep ov5642 [ 2.583901] ov5642 22-003c: Chip ID 0x5642 detected root@m3ulcb:~# capture -d /dev/video0 -F -f rgb32 -L 0 -T 0 -W 1280 -H 720 -c 1000 -t 60 -z fb0 Fixed Info: @ 0x57400000, len=8294400, line=7680 bytes, Geometry - 1280 x 800, 32 bpp /dev/video0 FPS: 29.1 (snip) /dev/video0 FPS: 29.1 root@m3ulcb:~#
- M3 SK (Connected: HDMI, Serial(cn12), Ether(cn7))
- KF M06(Connected: CMOS camera(cn29))
You do not have permission to edit this page, for the following reasons:
- The action you have requested is limited to users in the group: Users.
- You must confirm your email address before editing pages. Please set and validate your email address through your user preferences.
You can view and copy the source of this page.