Difference between revisions of "UDOO configure Ethernet under Android"
(first release) |
m |
||
Line 1: | Line 1: | ||
− | To configure Ethernet connection on UDOO under Android 4. | + | To configure Ethernet connection on UDOO under Android 4.3 you need to connect the board to a host computer. You need to plug a microUSB cable to i.MX6 debug serial UART on CN6 microUSB port. |
With a serial monitor it's possible to communicate with Android shell over serial uart. | With a serial monitor it's possible to communicate with Android shell over serial uart. | ||
Latest revision as of 08:28, 11 September 2014
To configure Ethernet connection on UDOO under Android 4.3 you need to connect the board to a host computer. You need to plug a microUSB cable to i.MX6 debug serial UART on CN6 microUSB port. With a serial monitor it's possible to communicate with Android shell over serial uart.
DHCP
When you connect the Ethernet cable the DHCP mode is selected by default.
Static Address
To configure a static ip address you need to open the i.MX6 debug console. Use the following command to set a static ip and a subnet mask:
ifconfig eth0 [YOUR_IP_ADDRESS] netmask [NETMASK]
Then configure the gateway ip using this command:
ip route add default via [GATEWAY_IP] dev eth0
DNS
To set different DNS you need to change the environment properties:
setprop net.dns1 [PRIMARY_DNS_IP_ADDRESS] setprop net.dns2 [SECONDARY_DNS_IP_ADDRESS]